There might be an option to parameterize these dimensions but I am not aware of it maybe you can access online website of SpaceClaim to check how that can be done if it is possible.įor DesignModuler in ANSYS, it is easy to parameterize the dimensions. As far as I can recall, you have to manually open the SpaceClaim everytime and then change these parameters manually. The problem with SpaceClaim, as I have observed, is that you cannot parameterize these dimensions. ![]() Then you can click on any edge, circle etc that you have sketched and change its dimension on the bottom left tree under 'General', as shown in the picture below. After making that sketch, you can click the option 'Dimensions' which can be seen in toolbar under 'Sketch' ribbon on top. I am going to assume you already know how to draw the sketch in SpaceClaim. On top of that, watch videos uploaded by other channels as which explains other SpaceClaim features in detail. If you are new to ANSYS and SpaceClaim, then the first thing you should do is just open YouTube, open ANSYS Learning Channel and watch the tutorials for SpaceClaim there.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |